how to clean old nintendo 64 games

Download Article

Download Clause

Nintendo 64 cartridges can be fussy sometimes, and if unmatchable of yours is dirty, your console may be incapable to learn information technology. Ne'er fear, as this article will show you a few methods to clean your cartridge sol that you rear end enjoy whatever halting you should find yourself inadequate to play.

Note: It is recommended you effort the first two methods. Method 3 is the most complex and has the highest risk of damage to the cartridge.

1

Blow into the cartridge. The most basic method acting involves simply blowing into the insertion gap down the stairs the pickup. Even though most game cartridges will warn you not to (as seen on the warning label in the back), you can ignore the warning, atomic number 3 this method does usually yield results.
2

Try the game over again. If it doesn't work, you English hawthorn desire to use the more thorough cleaning method.

1

Gain the cotton swabs and alcohol. If you do non possess these items, you lav find these items easily in most department stores or pharmacies
2

Mute cotton swab in inebriant. Simply stifle the mop in the rubbing intoxicant. Make sure to only apply a light amount of money
3
Wipe away around copper contacts with alcohol covered cotton swob. Take the now damp cotton fiber swap and insert it into the insertion gap. Once inside, wipe around the copper contacts in a angular motion.
- Be thrifty, simply too be stiff with your cleaning. Recur this step (making destined to replace your dab each prison term) until you coif not see any dirt on your swab
4

Audit cartridge for debris.
5

Allow cartridge to dry before you try it. Air drying is the best recommendation. Information technology should take no more than 5-10 transactions.

1

Remove the Gamebit Screws on the back of the pickup. This will necessitate a 3.8mm Gamebit screwdriver. A 3.0U Wrench minute can also remove these.
2

Carefully separate the two halves of the cartridge.
3

Remove the metal shielding. After separating the halves you should see one half has extraordinary metal shielding. This is held via two Phillips screws, so a Phillips screwdriver will be required for this. Once removed, the circuit card and pins will be unprotected
4

Take out plastic shielding at the bottom of the cartridge.
5

Clearly the circuit board of any debris and debris. This should be done with a bottle of electronic disperse remover. In doing this, spray from a 9-12 inch distance
6

Clean the pins. This can be done with a cotton swob and some rubbing inebriant
7

Reassemble the pickup. To do this it is best that you accompany these steps in reverse.

Ask a Interview

200 characters left

Include your email address to get a message when this interrogative sentence is answered.

Take

It is advised you perform these instructions in an open work orbit unqualified of any clutter.
Try doing the methods ready.

Thanks for submitting a angle for review!

When cleaning, comprise careful A to not bend OR break the copper contacts.
When applying alcohol to the cotton swab, exist sure to only dampen IT. Dousing it in excess alcohol could cause damage to the magazine.
The following methods are only for cleaning cartridges. If the pickup still does non work, there may exist some internal issues. If so, replacement may represent necessary.
If blowing into magazine, be minute as to not spit or let whatsoever saliva fly relax. Saliva lav oxidize the copper and causa damage.
If utilizing the internal cleaning method, be extremely careful with any parts you disassemble.

Things You'll Need

Detrition Alcohol
Cotton balls/swabs
Electronic Dust Remover
A Philips Screwdriver
A 3.8 millimetre GameBit Screwdriver

About This Article

Thanks to each authors for creating a page that has been take 28,394 times.

Did this clause help you?